Golf Shoe Care

Proper care and attention is required to maintain and prolong the look, performance, feel and comfort of golf shoes. Faced with a wide range of hazards, both leather and synthetic golf shoes must be thoroughly cleaned and properly stored between rounds in order to prolong the look and life of the shoes.

  • We recommend rotating shoes between rounds - properly maintained the rotation of two pairs of shoes will last much longer than twice the life of a single pair.
  • Use a shoe horn when putting on your golf shoes to protect the heel counter of the shoe.
  • Check your cleats between rounds to ensure they are intact and secured properly into their respective receptacles, but DO NOT OVER TIGHTEN your cleats.
  • Do not store your golf shoes in your car trunk, where high temperatures can break down shoe materials resulting in decreased lifespan of your shoes.
  • We strongly recommend leaving Cedar shoe trees in your golfing shoes at all times when shoes are not in use.

Cleaning Guidelines

  1. Pre-Round Shoe Care
  2. Post-Round Shoe Cleaning & Care
  3. Cleaning Mesh Shoes
  4. Cleaning Men's HyperFlex

    5. Pre-Round Shoe Care

    Use a shoe horn when putting on your golf shoes. This will protect the heel counter of the shoe. Damage to the heel counter can cause improper fit in the heel which can lead to blistering and overall discomfort.

    Back to top


    Post-Round Shoe Cleaning & Care

    Uppers

    Clean leather or synthetic golfing shoes after each round by removing dirt and residue using a shoe cleaner or mild soap and water. Allow to air dry at room temperature.

    White Shoes: To clean shoes with a white base leather, apply white shoe cleaner to remove unwanted scuff marks. This will also condition the leather.

    Dark Shoes: To clean shoes with a dark base leather use a combination of a shoe cleaner and an applicable color shoe cream to maintain the look and conditioning of the full grain or calfskin leather.

    Wet Shoes: If your shoes become soaked during a round,

    1. Clean them quickly.
    2. Place crumpled newspaper inside for 8-10 hours to soak up all excess water.
    3. Remove newspaper and replace with FootJoy Cedar Shoe Trees. Cedar shoe trees will bring the uppers back to normal shape, smooth the linings and absorb any remaining water and odor. The absorption properties of cedar make them far more effective than plastic shoe trees.

    General Tips:

    • Remove the laces when cleaning.
    • If not glued into the shoe, remove the inner sole when cleaning your golf shoes.
    • Do not place your shoes in direct sunlight to dry, but rather allow them to air-dry in a shaded area or indoors.
    • NEVER dry your shoes using a blow-dryer or by putting them on any external heat source. Excessive heat can damage both the uppers and the outsoles.

    Outsole Care

    All non-leather outsoles should be wiped clean of dirt and residue after every round.

    Check to ensure that all cleats are intact and secured properly into their respective receptacles.DO NOT OVER-TIGHTEN THE CLEATS.

    Do not store your golf shoes in your car trunk, where high temperatures can break down shoe materials resulting in decreased lifespan of your shoes.

    Back to top


    Cleaning Mesh Shoes

    Hand Cleaning Mesh Shoes

    1. Soak in the sink with a squirt of liquid dish soap or laundry detergent and warm water.
    2. Dip a soft cloth or soft-bristled cleaning brush in the soapy water. Scrub the mesh to remove dirt, dust and residue.
    3. Blot or dab at the mesh with a cold water dampened cloth to remove soap residue.
    4. Allow the golf shoes to air dry. Do not place the shoes directly in the sun, but rather allow them to air-dry in a shaded area or indoors.

    Back to top


    Cleaning Men's HyperFlex

    Step 1: Ensure your shoes are completely dry and that the shoe laces have been removed. Starting with a dry shoe surface helps to easily remove mud and dirt.

    Step 2: Use a dry brush (with firm bristles) to gently brush off any dirt from your pair of shoes.

    Step 3: Next, wipe off any excess debris from your pair of shoes to ensure all small dirt particles are completely removed.

    Step 4: Add a tablespoon of cleaning solution to a bowl of room temperature water. Next, dip a clean brush (with soft bristles) into the bowl.

    Step 5: Gently scrub shoes until solution starts to bubble.

    Step 6: Wipe off excess solution with a towel.

    Step 7: Once your pair of golf shoes are cleaned, remove the Fit-Bed® insole and place both shoe laces in the bowl of water and cleaning solution. Remove from solution after 10-15 minutes and allow to air dry -- or blow dry for faster results.

    Step 8: Allow both your shoes and shoe laces to completely dry before re-lacing and inserting the Fit-Bed® insoles.

    Back to top